Features

• NEW: Advanced hybrid construction combining wood and composite materials for a reinforced fuselage and wings, delivering maximum strength with low weight
• NEW: Patented quick-release system for wings, stabilizer, and SFG for fast and easy assembly
• NEW: Patented quick-release canopy system, ideal for electric setups with quick battery access
• Covered with genuine German Oracover (Ultracote) for a premium finish and durability
• Highly prefabricated design – experienced builders can have the model flight-ready within a day
• Factory-installed hinges (glued and pinned) for reliability and precision
• Internal cowling mounting system for a clean look (only two screws underneath for easy access)
• Removable wings and stabilizers for convenient transport
• Laser-engraved motor mounting position for accurate installation
• Open structure design allows easy installation of canister exhaust systems
• Pull-pull system included for precise rudder control
• Cowling compatible with both gasoline (single and twin cylinder) and electric power setups

Note: Due to the hybrid construction, this model does not include free replacement wood parts.

Included Hardware

• Complete airframe with all essential accessories
  (including carbon fibre main landing gear, tail gear assembly, wing tubes, fibreglass control horns, and wheel pants)
• Pre-installed hinges and pre-mounted canopy
• Fuel tank with pre-installed tubing, fuel dot, and breather valve
• Wheels, axles, and wheel pants
• Pre-prepared pushrods with ball links
• Matching carbon spinner

REQUIRED HARDWARE:

Motor: 30-40cc or equivalent electric

Servos: 5 high torque (minimum 20kg) 20x40mm AGF A73 V2 40KG  plus throttle // Uses x1 per aileron, x1 per elevator 15x35 mm A35BHLP 22KG and x1 on rudder AGF A73 V2 40KG

Also requires all the usual accessories such as transmitter, receiver, propeller, batteries, powerbox, extension leads and possibly other accessories.

Build information

COWL SIZE:

EXHAUST TUNNEL SIZE:

RUDDER HORNS AND PULL PULL LOCATION:

EXTENSION WIRE LENGTHS:

Throttle:
10cm

Each aileron:
25cm
(to reach receiver direct)

Each elevator:
70cm

Rudder:
Pull pull, no extension required

CENTER OF GRAVITY:

180mm
Measured back from leading edge of the wing at the fuselage.

You will find a laser engraved C.G. emblem on the inside of the fuselage, located close to the wing tube, which also shows the exact location for Center of Gravity.

Manual: HERE