Do I need to drill new sensor or fog light holes?

Check your OEM bumper cutout locations before installation. If your vehicle has factory sensors or fog lights in the rear bumper, you'll need to verify hole alignment with this panel and drill accordingly. Reference your vehicle's service manual for exact mounting points.

Will this fit my trailer hitch clearance?

Measure your hitch receiver depth and the mounting point location on your rear frame before ordering. This bumper is a direct bolt-on replacement, so if your hitch is recessed or flush-mount, you should have no interference. If you run an extended or ball-mount hitch, verify clearance independently.

What should I do to prepare this for paint?

Sand and prep the surface with appropriate grit progression before applying primer and paint. FRP typically requires light scuffing to accept your chosen finish. Always follow your paint supplier's prep guidelines for best adhesion and durability.