1. Install the spacer inside the U-Bolt based on the clamping position and size.
2. Tighten the universal joint onto the U-Bolt securely before use.
3. The included washer pairs consist of two washer sets. Take care not to lose these during disassembly, as losing a washer may cause the nut to loosen under vibration.
4. U-Bolt can be installed onto the motorcycle frame, rear pedal bracket, bumper, and other secure areas. Always check the U-Bolt is locked into place, without rotation or play in the mount when secured.
5. Riding is only recommended on smooth roads at speeds not exceeding 80km/h (50mph). Off-road riding is not supported.
6. It is recommended to use only the Insta360 Action Invisible Selfie Stick with this accessory. Do not attach any other accessories to the mount or the selfie stick when in use. Applying force to the selfie stick may damage the universal joint. This mount is not compatible with the Insta360 Extended Edition Selfie Stick.
7. You can use zip ties to secure the selfie stick to the bike's tail for greater stability. Ensure that only the 1/4" mounting point on the bottom of the selfie stick and the zip tie are in contact with the bike to prevent damage to the selfie stick.
8. When the motorcycle is parked outside for an extended period, remove accessories to keep them in the best condition.
9. Please use the accessory according to the installation method in this instruction manual, do not DIY. Damage caused by not following the instructions will not be covered by Insta360 warranty or replacement services.

Insta360 doesn't offer legal advice. Motorcycle riders should consult professionals for road use and traffic law guidance. Always follow local laws and regulations when using Insta360 products. Insta360 is not liable for any legal issues that may arise from improper use of its products.